You need to figure out which of these possible things are wrong with the blower. Then the ignitor will time out after 5 sec if the flame sensor does not sense ignition. Make sure your pump lid is free of cracks and the O-ring is smooth and undamaged to ensure a perfect seal and no air leaks. You should smell gas if it is the ignitor as it tries to light and then gives up. What does ENA mean in a Jandy pool heater? blower comes on, ignitor glows then blower goes off and ignitor turns off. It could be something silly like a stick or acorn is stuck in it's intake. There are several potential causes, most pretty easy to fix but require taking some of the heater panels off. No other "low-hanging fruit" you guys can think of? Once I installed a local regulator, it worked the first time. 5 5 comments Best Add a Comment TehSpaz 5 yr. ago I decided to get out and turned it off. I would try the simple stuff first. Paste as plain text instead, NEXT IM GOING TO THROW AN IGNITION CONTROL MODULE AT IT, HAVE IT IN A COUPLE DAYS. Each wire is attached to a push-on clip that can be removed from the terminal. Do I need to use a mirror on the bottom of the heater? So, without a working igniter, you cant get your Jandy pool heater to light up. or Propane?). If it's not the breaker are you comfortable working inside the heater electronics with 240 v power? Yes, exactly and it fires up normally after that. A tripped breaker or fuse is one of the most typical causes. Section 5. I usually check these by disconnecting all power to the unit and then use my screwdriver to see if I can manually turn the fan blades. Any new postings here are unlikely to be seen or responded to by other members. Also, replace any damaged or cracked fittings leading into the pump. Still havent had a plumber come. Please include what you were doing when this page came up and the Cloudflare Ray ID found at the bottom of this page. However, tonight, it had one.
Chris And Robin Sorensen Net Worth, Articles J