Turske Serije Balkanje Nove, Articles M

These segments are determined in relation to the axis of reference. 7.2.7. Annex 1 Communications concerning the approval (or refusal or withdrawal of approval or production definitely discontinued) of a vehicle type with regard to the installation of lighting and light-signalling devices, pursuant to Regulation No. Aggregate maximum intensity of the driving beam headlamps which can be switched on simultaneously shall not exceed 225,000 cd. Position. This makes it clear that filtering over the speed limit of 30km/h is illegal. If a reflector is mounted on a side car, the points of the illuminating surface which is farthest from the motor cycle shall not be more than 400mm from the extreme outer edge of the side-car. REAR-REGISTRATION-PLATE ILLUMINATING DEVICE. This requirement is regarded as satisfied if the light emitted does not cause discomfort to the driver either directly or indirectly by means of the rear-view mirrors and/or reflective surfaces of the vehicle. Electrical connections and tell-tales. Arrangement, Arrangement A one at the front to ADRs 53 or 49, Arrangement B two at the front to ADRs 53 or 49, Arrangement C - one at the rear to ADRs 53 or 49, Arrangement D two at the rear to ADRs 53 or 49, Arrangement E one on each side (amber to side acceptable). EXEMPTIONS AND ALTERNATIVE PROCEDURES. direction-indicator lamp means the lamp used to indicate to other road-users that the driver intends to change direction to the right or to the left; A direction-indicator lamp or lamps may also be used according to provisions of Regulation No. Indicators are required on all motorcycles manufactured after 30 June 1975. 0.1.2. The presence of partitions or other items of equipment near the head-lamp shall not give rise to secondary effects causing discomfort to other road users. If measurements are taken closer to the lamp, the direction of observation must be shifted parallel to achieve the same accuracy. REVERSING LAMP, 7.2.1. The vertical angle below the horizontal may be reduced to 5, if the height of the lamp is less than 750 mm. STEAMER. Motorcyclists can lane filter through stationary and slow moving traffic. = clause renumbered. 53, as amended by the 01 series of amendments. Submitted for approval on: 6. Orientation, 7.2.6. 0000000016 00000 n To be registered, your vehicle must be suitable for safe use (roadworthy) and meet the standards required by law. The lamp(s) may move in line with the steering angle. Filtering only permitted when it is safe to do so. Motorcycle standards - Department of Transport and Main Roads a vehicle travelling in the same direction as the motorcycle and an adjacent parked vehicle or line of parked vehicles. This requirement shall be deemed to be satisfied if the light emitted can not be seen by the driver either directly or indirectly through the rear vision mirror and/or other reflecting surfaces of the vehicle. Application for approval, 6. REQUIREMENTS. The vehicle-hazard warning signal shall remain capable of being actuated even when the device which controls the starting and stopping of the engine is in such a position that operation of the engine is impossible. PASSING LAMP, 8.2.1. 51 21 When the rear registration plate lamp is combined with the rear position lamp, reciprocally incorporated in the stop lamp or in the rear fog lamp, the photometric characteristics of the rear registration plate lamp may be modified during the illumination of the stop lamp or the rear fog lamp.